lts.conf file
# Config file for the Linux Terminal Server Project (www.ltsp.org)
#
[Default]
SERVER = 192.168.10.26
XSERVER = auto
X_MOUSE_PROTOCOL = "PS/2"
X_MOUSE_DEVICE = "/dev/psaux"
X_MOUSE_RESOLUTION = 400
X_MOUSE_BUTTONS = 3
USE_XFS = N
LOCAL_APPS = Y
RUNLEVEL = 5
# Example of specifying X settings for a workstation
#ltsp and si are the names of the machine I have chosen as workstations
[ltsp]
XSERVER = auto
LOCAL_APPS = Y
USE_NFS_SWAP = N
SWAPFILE_SIZE = 48m
RUNLEVEL = 3
[si]
XSERVER = XF86_SVGA
LOCAL_APPS = Y
USE_NFS_SWAP = N
SWAPFILE_SIZE = 64m
RUNLEVEL = 3
#
# ws004 is my virtual workstation running in a VMware session
#
#[ws004]
# DNS_SERVER = 192.168.10.50
# XSERVER = auto
# X4_BUSID = "PCI:0:15:0"
# X_MODE_0 = 800x600
# LOCAL_APPS = N
# USE_NFS_SWAP = N
# SWAPFILE_SIZE = 64m
# RUNLEVEL = 5
# Example of a workstation configured to load some modules
#
#[ws001]
# MODULE_01 = agpgart.o # This is for i810 video
# MODULE_02 = uart401.o
# MODULE_03 = sb.o io=0x220 irq=5 dma=1
# MODULE_04 = opl3.o
# Example of ws001 configured for local apps
#
#[ws001]
# LOCAL_APPS = Y
# LOCAL_WM = Y
# NIS_DOMAIN = ltsp
# NIS_SERVER = 192.168.10.254
# Example of a serial printer attached to /dev/ttyS1 on workstation ws001
#
#[ws001]
# PRINTER_0_DEVICE = /dev/ttyS1
# PRINTER_0_TYPE = S # P-Parallel, S-Serial
# PRINTER_0_PORT = 9100 # tcp/ip port: defaults to 9100
# PRINTER_0_SPEED = 9600 # baud rate: defaults to 9600
# PRINTER_0_FLOWCTRL = S # Flow control: S-Software (XON/XOFF), H-Hardware (CTS/RTS)
# PRINTER_0_PARITY = N # Parity: N-None, E-Even, O-Odd (defaults to 'N')
# PRINTER_0_DATABITS = 8 # Databits: 5,6,7,8 (defaults to 8)